Frequently Asked Questions

The measure excludes plan members who are not ambulatory from the measure rate, but it is not necessary to report the number of members excluded with the measure’s performance rate.

FAQ ID:89006

No, a specific screening tool is not required for this measure. However, potential screening tools may include the Morse Fall Scale and timed Get-Up-And-Go test.

FAQ ID:89011

A falls screening is an evaluation of whether a Managed Long Term Services and Supports plan member has experienced a history of falls and/or problems with balance or gait. A falls risk assessment includes a balance/gait assessment and one other assessment component and should only be performed for members with a documented history of falls (at least two falls or one fall with injury in the past year).

FAQ ID:89016

The MLTSS assessment and care planning measures include:

• LTSS Comprehensive Assessment and Update
• LTSS Comprehensive Care Plan and Update
• LTSS Shared Care Plan with Primary Care Practitioner(PCP)
• LTSS Reassessment/Care Plan Update after Inpatient Discharge
• Screening, Risk Assessment, and Plan of Care to Prevent Future Falls: Falls Part 1 (Screening) and Falls Part 2 (Risk Assessment and Plan of Care)

FAQ ID:89066

It is recommended that MLTSS plans report both rates. However, if the state believes there are valid reasons for not reporting both rates, such as costly changes in assessment and care planning forms and information technology systems, it might consider phasing in the supplemental rates over time. For instance, in the first year of measure use (for example, measurement year 2018), the state could require MLTSS plans to report just the core rate, and then require that MLTSS plans report both core and supplemental rates for measurement year 2019 or 2020. Although they are called "supplemental rates," they are still very important, and should be viewed as "aspirational." MLTSS plans should strive to cover more assessment and care plan elements over time.

FAQ ID:89071

Value sets are the complete set of procedure and diagnostic codes used to identify a service or condition included in a measure. One of the assessment and care planning measures—LTSS Reassessment/Care Plan Update after Inpatient Discharge—uses value sets to identify potentially planned hospitalizations. Please see "Do I need to use value sets to calculate these measures? If so, where can I find the value sets?" for more information regarding using value sets for the three institutional rebalancing and utilization measures.

View the value sets (XLSX, 2.88 MB). Please see Table 2 in the "LTSS Value Sets to Codes" tab. Table 1 in the "LTSS Measures to Value Sets" tab shows each value set needed for each measure.

FAQ ID:89076

Yes, the same sample can be used for Part 1 of the Screening, Risk Assessment, and Plan of Care to Prevent Future Falls measure as the LTSS Comprehensive Assessment and Update, LTSS Comprehensive Care Plan and Update, and LTSS Shared Care Plan with Primary Care Practitioner measures.

FAQ ID:89081

No, for the LTSS Comprehensive Care Plan and Update measure, the care plan does not have to take place in the member’s home. However, it must be done face-to-face unless certain exceptions are met. These exceptions include circumstances in which:

• The member was offered a face-to-face discussion and refused (either refused a face-to-face encounter or requested a telephone discussion instead of a face-to-face discussion).
• The state policy, regulation, or other state guidance excludes the member from a requirement for face-to-face discussion of a care plan.

FAQ ID:89146

Use the most recently updated care plan.

FAQ ID:89151

To meet the LTSS Comprehensive Care Plan and Update measure numerator, the care plan must be signed by the member, unless the care plan is under appeal in the specified timeframe, and there is documentation that the care plan was in appeal. There is an exclusion for members who refuse to take part in care planning. This exclusion is reported with the measure rate, so the overall measure rate can be interpreted correctly. For example, a plan that is not successful at engaging members in care planning, indicated by a high exclusion rate, would suggest the overall rate on the measure should be interpreted with caution.

FAQ ID:89166