Frequently Asked Questions

The MLTSS assessment and care planning measures include:

• LTSS Comprehensive Assessment and Update
• LTSS Comprehensive Care Plan and Update
• LTSS Shared Care Plan with Primary Care Practitioner(PCP)
• LTSS Reassessment/Care Plan Update after Inpatient Discharge
• Screening, Risk Assessment, and Plan of Care to Prevent Future Falls: Falls Part 1 (Screening) and Falls Part 2 (Risk Assessment and Plan of Care)

FAQ ID:89066

It is recommended that MLTSS plans report both rates. However, if the state believes there are valid reasons for not reporting both rates, such as costly changes in assessment and care planning forms and information technology systems, it might consider phasing in the supplemental rates over time. For instance, in the first year of measure use (for example, measurement year 2018), the state could require MLTSS plans to report just the core rate, and then require that MLTSS plans report both core and supplemental rates for measurement year 2019 or 2020. Although they are called "supplemental rates," they are still very important, and should be viewed as "aspirational." MLTSS plans should strive to cover more assessment and care plan elements over time.

FAQ ID:89071

Value sets are the complete set of procedure and diagnostic codes used to identify a service or condition included in a measure. One of the assessment and care planning measures—LTSS Reassessment/Care Plan Update after Inpatient Discharge—uses value sets to identify potentially planned hospitalizations. Please see "Do I need to use value sets to calculate these measures? If so, where can I find the value sets?" for more information regarding using value sets for the three institutional rebalancing and utilization measures.

View the value sets (XLSX, 2.88 MB). Please see Table 2 in the "LTSS Value Sets to Codes" tab. Table 1 in the "LTSS Measures to Value Sets" tab shows each value set needed for each measure.

FAQ ID:89076

Yes, the same sample can be used for Part 1 of the Screening, Risk Assessment, and Plan of Care to Prevent Future Falls measure as the LTSS Comprehensive Assessment and Update, LTSS Comprehensive Care Plan and Update, and LTSS Shared Care Plan with Primary Care Practitioner measures.

FAQ ID:89081

Yes, the assessment for the LTSS Comprehensive Assessment and Update measure is required to take place in the member’s home as a face-to-face discussion unless certain exceptions are met. These exceptions include circumstances in which:

• The member was offered an in-home assessment and refused the in-home assessment (either refused to allow the care manager into the home or requested a telephone assessment instead of an in-home assessment).
• The member is residing in an acute or post-acute care facility (hospital, skilled nursing facility, other post-acute care facility) during the assessment time period.
• The state policy, regulation, or other state guidance excludes the member from a requirement for in-home assessment.

FAQ ID:89086

There must be documentation of the refusal, which would result in exclusion from the measure. The rate of exclusion due to a member refusing to participate should also be reported along with the measure performance rate.

FAQ ID:89101

There must be documentation that at least three attempts were made to reach the member, and that the member could not be reached, which would result in exclusion from the measure. The rate of exclusion due to inability to reach a member should also be reported along with the measure performance rate.

FAQ ID:89106

In accordance with Medicare cost reporting, the state must use 12 months of cost data reported by each facility. With regard to payment data, the state should use actual amounts, to the extent available, then calculate a claims completion factor based on historic utilization. The state’s UPL submission must include an explanation of its methodology to estimate payments. The use of a claims completion factor provides a reasonable estimate of the amount that Medicare would pay for these services, consistent with the UPL as defined at 42 CFR 447.272.

FAQ ID:92446

Yes. Mapping data, through V-Look-ups, for example, is a much easier and consistent process for current and future UPL submissions. However, a state may choose to type information and data into unlocked fields in the UPL templates. When a state chooses to input data directly (not through a V-Look-up) into the template, it still must provide the supporting documentation with the source data. Additionally, the state should explain how it mapped data from the supporting documentation into the template. The Centers for Medicare & Medicaid Services utilizes the supporting information to confirm that the information in the templates is correct.

FAQ ID:92451

Effective state fiscal year 2020, each state must submit a complete data set of payments to Medicaid providers, including providers paid at cost, as well as critical access hospitals. This would require states to submit cost and payment data to CMS that previously was not requested.

FAQ ID:92456