U.S. flag

An official website of the United States government

Frequently Asked Questions

Frequently Asked Questions are used to provide additional information and/or statutory guidance not found in State Medicaid Director Letters, State Health Official Letters, or CMCS Informational Bulletins. The different sets of FAQs as originally released can be accessed below.

Showing 1 to 10 of 85 results

Which measures assess institutional rebalancing and utilization measures?

The following measures assess institutional rebalancing and utilization:

  • LTSS Admission to an Institution from the Community
  • LTSS Minimizing Institutional Length of Stay
  • LTSS Successful Transition after Long-Term Institutional Stay

FAQ ID:91101

SHARE URL

Do I need to use value sets to calculate these institutional rebalancing and utilization measures? If so, where can I find the value sets?

Yes. Value sets are the complete set of procedure and codes used to identify a service or condition included in a measure. All three of the rebalancing measures—LTSS Admission to an Institution from the Community, LTSS Minimizing Institutional Length of Stay, and LTSS Successful Transition after Long-Term Institutional Stay—use the "Institutional Facility"value set (XLSX, 2.88 MB). See Table 2 in the "LTSS Value Sets to Codes" tab. Table 1 in the "LTSS Measures to Value Sets" tab shows each value set needed for each measure.

FAQ ID:91106

SHARE URL

Should unpaid or denied claims be included in calculating the institutional utilization and rebalancing measures?

No, include paid claims only (days denied for any reason should not be included) for all three of the rebalancing measures—LTSS Admission to an Institution from the Community, LTSS Minimizing Institutional Length of Stay, and LTSS Successful Transition after Long-Term Institutional Stay.

FAQ ID:91111

SHARE URL

Are there exclusions for the Long Term Services and Supports Admission to an Institution from the Community measure's eligible population (denominator)?

No. However, when identifying the measure’s denominator from the eligible population, there are a few cases in which you should not include member months. For example, do not include months when the plan member was residing in an institutional facility for the entire month (that is, there were no days in the month spent residing in the community). If a member died, do not include the month during which the member died and any subsequent months of enrollment in the measure’s denominator.

FAQ ID:91116

SHARE URL

Are there exclusions for the Long Term Services and Supports Admission to an Institution from the Community measure's numerator?

When calculating the measure’s numerator (number of admissions to an institution), do not include admissions that are direct transfers from another institution, admissions from the hospital that originated from an institution, or admissions for individuals who do not meet the continuous enrollment criteria. If the member’s admission resulted in death in the institution or death within one day of discharge from the institution, do not include the admission in the numerator.

FAQ ID:91121

SHARE URL

Can the community residence include assisted living?

Yes, people admitted to an institution who were residing in the community prior to their admission may include those residing in assisted living, adult foster care, or another setting that is not defined as an institution.

FAQ ID:91131

SHARE URL

Is the Long Term Services and Supports Admission to an Institution from the Community measure risk-adjusted?

Yes, this measure is risk-adjusted, using risk stratification by age. Results are reported separately for four age groups (18-64, 65-74, 75-84, 85 and older) for each of the length of stay classifications (short-term stay, medium-term stay, and long-term stay).

FAQ ID:91136

SHARE URL

When a facility has been in operation for the dates of service covered by the Upper Payment Limit (UPL) demonstration, can a state demonstrate the UPL by using less than 12 months of data?

In accordance with Medicare cost reporting, the state must use 12 months of cost data reported by each facility. With regard to payment data, the state should use actual amounts, to the extent available, then calculate a claims completion factor based on historic utilization. The state’s UPL submission must include an explanation of its methodology to estimate payments. The use of a claims completion factor provides a reasonable estimate of the amount that Medicare would pay for these services, consistent with the UPL as defined at 42 CFR 447.272.

FAQ ID:92446

SHARE URL

Can a state type information and data into unlocked fields in the Upper Payment Limit (UPL) templates or must the data from state-developed UPL reports/workbooks be mapped through, for example, V-Look-ups into the UPL templates?

Yes. Mapping data, through V-Look-ups, for example, is a much easier and consistent process for current and future UPL submissions. However, a state may choose to type information and data into unlocked fields in the UPL templates. When a state chooses to input data directly (not through a V-Look-up) into the template, it still must provide the supporting documentation with the source data. Additionally, the state should explain how it mapped data from the supporting documentation into the template. The Centers for Medicare & Medicaid Services utilizes the supporting information to confirm that the information in the templates is correct.

FAQ ID:92451

SHARE URL

What data should my state provide to the Centers for Medicare & Medicaid Services (CMS) for the annual Upper Payment Limit demonstrations?

Effective state fiscal year 2020, each state must submit a complete data set of payments to Medicaid providers, including providers paid at cost, as well as critical access hospitals. This would require states to submit cost and payment data to CMS that previously was not requested.

FAQ ID:92456

SHARE URL
Results per page