Frequently Asked Questions are used to provide additional information and/or statutory guidance not found in State Medicaid Director Letters, State Health Official Letters, or CMCS Informational Bulletins. The different sets of FAQs as originally released can be accessed below.
Frequently Asked Questions
What was the traditional Medicaid Eligibility Quality Control (MEQC) program based on and how has it changed?
The traditional MEQC program at 42 CFR § 431.810 through 431.822 was originally designed to implement sections 1902(a)(4) “Administration Methods for Proper and Efficient Operation of the State Plan” and 1903(u) “Limitation of FFP for Erroneous Medical Assistance Expenditures” of the Social Security Act (the Act). The program required annual state reviews of Medicaid cases identified through a statistically valid statewide sample of cases selected from the state’s eligibility files. The reviews were conducted to determine whether the sampled cases meet applicable Medicaid eligibility requirements. The program evolved over time to allow states the option of selecting specific areas of focus within the Medicaid program for their annual MEQC reviews.
On July 5, 2017, CMS published a final regulation entitled “Changes to the Payment Error Rate Measurement (PERM) and Medicaid Eligibility Quality Control (MEQC) Programs (CMS-Medicaid Coordination of Benefits8- F).” This final rule updated the MEQC and PERM programs based on the changes to Medicaid and Children’s Health Insurance Program eligibility requirements under the Patient Protection and Affordable Care Act. The new regulation has restructured the MEQC program into an ongoing series of pilots that states are required to conduct during the two off-years between triennial PERM review years. The MEQC portions of the regulation are now covered by 42 CFR §§ 431.800-820.
FAQ ID:93416
SHARE URLWhat deliverables must states furnish to the Centers for Medicare & Medicaid Services (CMS) per the new Medicaid Eligibility Quality Control (MEQC) regulation?
The regulation requires states to submit a pilot planning document to CMS by November 1 of the year in which each state’s PERM review year ends. The pilot planning document must describe how states will conduct their active and negative case reviews and must be approved by CMS before the MEQC pilots can begin. In addition, the regulation requires states to submit case-level reports and corrective action plans to CMS by August 1 of the year after the MEQC review period ends. The specifications for the MEQC pilot planning documents are provided in the MEQC sub-regulatory guidance effective August 29, 2018. More details on the specifications of the case-level reports and corrective action plans are included in a second round of guidance, MEQC sub-regulatory guidance effective October 22, 2018.
FAQ ID:93421
SHARE URLHow will the Medicaid Eligibility Quality Control (MEQC) program be realigned under the final regulation issued July 5, 2017?
As reconfigured under the final regulation of July 5, 2017, MEQC will work in conjunction with the Payment Error Rate Measurement (PERM) program. In those years when states undergo their triennial PERM reviews, the states will not conduct MEQC pilots. The latter will only be required in the two off-years between PERM review years. CMS has restructured the MEQC program so that it more effectively complements the PERM program and provides states with the necessary flexibility and opportunity to target specific problems or high-interest areas during the two off-years of the PERM cycle.
FAQ ID:93146
SHARE URLHow does Medicaid Eligibility Quality Control (MEQC) differ from Payment Error Rate Measurement (PERM)?
The MEQC requirements on active case reviews generally mirror the requirements of the eligibility component of PERM reviews. The regulation requires that states perform reviews of a sample of active Medicaid and Children’s Health Insurance Program (CHIP) cases to identify new eligibility approvals and renewals that were made in error. As in PERM, states will be required to submit case-level reports on the sampled cases they review and corrective action plans that describe steps taken to remediate the errors found.
However, in contrast to PERM, when states identify errors in their active Medicaid and CHIP cases, they will be required to undertake a payment review. This will consist of a review of all claims paid over the first three months after an erroneous eligibility determination was made, and a summary of the overstated or understated liability. States will in turn be required to submit adjustments to the amount of federal financial participation (FFP) claimed through the CMS-64 reporting process for Medicaid and the CMS-21 reporting process for CHIP. The adjustments are required for identified claims in which too much or too little FFP was received. There is no payment review or re-crediting requirement in PERM, although disallowance of FFP can be taken in states whose PERM error rate exceeds the national threshold of 3% based on a formula described at 42 CFR 431.1010. MEQC contains no such disallowance provision.
The MEQC program also contains one other significant element that is not found in PERM. Besides the requirement that states review at least 400 cases in their active case universe (including a minimum of 200 cases), MEQC requires states to review at least 400 negative case actions. At least 200 of these must be Medicaid and 200 must be CHIP. Negative case actions involve erroneous denials of Medicaid or CHIP eligibility or erroneous terminations from Medicaid or CHIP. This is an area with no PERM counterpart in which states will be developing case-level reporting and corrective actions. Negative case action reviews will not be triggered by PERM findings. Largely for this reason, the regulation requires that states pull their sample of these from the entire Medicaid and CHIP universe of cases. By sampling from the full range of Medicaid and CHIP cases, states should be able to obtain an overview of those sectors in their programs that may be especially vulnerable to improper denials or terminations.
FAQ ID:93196
SHARE URLIs there a simplified Payment Error Rate Measurement (PERM)/Medicaid Eligibility Quality Control (MEQC) timeline with milestone dates/cycles that can be provided to states (all cycles)?
The PERM/MEQC dates/cycles are as follows:
PERM Cycle* | PERM Review Period | MEQC Planning Document Due to CMS | MEQC Review Period | MEQC Case-Level Report on Findings and CAP Due to CMS |
---|---|---|---|---|
Cycle 1 | July 1, 2017 – June 30, 2018 | November 1, 2018 | January 1 – December 1, 2019 | August 1, 2020 |
Cycle 2 | July 1, 2018 – June 30, 2019 | November 1, 2019 | January 1 – December 1, 2020 | August 1, 2021 |
Cycle 3 | July 1, 2019 – June 30, 2020 | November 1, 2020 | January 1 – December 1, 2021 | August 1, 2022 |
*??
CMS = Centers for Medicare & Medicaid Services
CAP = ??
FAQ ID:95156
SHARE URLDoes CMS require states to submit their 2019 Upper Payment Limit (UPL) demonstrations using the Office of Management and Budget (OMB) approved templates for Inpatient Hospital services (IPH), Outpatient Hospital services (OPH), and Nursing Facility services (NF) UPLs?
Yes, CMS requires states to use all of the OMB approved templates for their 2019 (07/01/2018 to 06/30/2019) UPL demonstrations submitted to meet the annual UPL reporting requirement and with State Plan Amendment (SPA) submissions. When submitting UPL demonstrations, use the following naming convention: UPL_<UPL Demo Date Range>_<Service Type Abbreviation>_R<Region Number>_<State Abbreviation>_<Workbook Number>.xls. Here is an example of the naming convention: UPL_20170701-20180630_IP_R01_CT_01.xls.
FAQ ID:92196
SHARE URLShould the period of time covered by the Upper Payment Limit (UPL) demonstration be tied to the state's fiscal year?
No, CMS does not require any particular starting point within the fiscal year for the UPL demonstrations. This allows states the flexibility to develop UPL demonstrations that are tied to the provider payment periods described in the state plan payment methodologies for each service. For instance, if a state submits a state plan amendment to update provider payments as of October 1 of each year, the state would document that the SPA changes comply with the UPL for the period 10/1 - 9/30 of that payment year. The UPL must represent the entire payment year. Since UPL demonstrations usually rely on historic data that is projected into a payment year, this is consistent with past practices.
FAQ ID:92226
SHARE URLCan states that pay for inpatient hospital services using Diagnosis Related Grous (DRGs), but historically used a cost-based UPL, continue to use the cost-based Upper Payment Limit (UPL) method?
Yes, states may use UPL methodologies that are different from their payment methodologies. For example, a state may pay for inpatient hospital services using a Medicaid APR-DRG methodology, but use a cost methodology to compute the Medicare upper payment limit for its UPL demonstration.
FAQ ID:92386
SHARE URLThis table indicates what reports are available to CMS Users. These can be found under the "Reports" tab.
Report Name |
Description |
Available For |
Clock Status Report |
View the regulatory clock statuses |
CPOC, CMS Disapproval Coordinator, SRT Admin CMS Report Admin, |
State Agency Profile Report |
Overview of a State's Medicaid Plan including the prior 12 months' submission package history |
CPOC, CMS Disapproval Coordinator, SRT Admin, CMS Report Admin, CSA, SRT |
Submission Detail Report |
View details on packages by date |
CPOC, CMS Disapproval Coordinator, SRT Admin, CMS Report Admin, SME, PA, PD,SRRVW, SRT |
Submission Statistics Detail Report |
View all Submission Packages currently in review |
CPOC, CMS Disapproval Coordinator, SRT Admin, CMS Report Admin, SME, PA, PD, SRRVW, SRT |
Submission Statistics Summary Report |
View summary of Submission Packages in a specific review status within a specified date range. |
CPOC, CMS Disapproval Coordinator, SRT Admin, CMS Report Admin, SME, PA, PD,SRRVW, SRT |
Submission Summary Report |
Overview of submitted packages by date |
CPOC, CMS Disapproval Coordinator, SRT Admin, CMS Report Admin, SME, PA, PD,SRRVW, SRT |
Staff Workload Report |
View the number of Submission Packages assigned to each CPOC and SRT member, as of the report run date. |
CMS Disapproval Coordinator, SRT Admin, CMS Report Admin, CSA |
FAQ ID:92871
SHARE URLWhat is the Review Tool Report?
The Review Tool Report is a feature CPOCs, SRTs, Senior Reviewers, Package Approvers, Package Disapprovers, and CMS Report Admins can utilize to see Package Reviewable Units, Reviewers, Reviewable Unit Assessment Values, and Notes.
Log in as CMS Point of Contact or Submission Review Team member. Under the "Records" tab, select "Submission Packages". Then select the link to the submission package. In the left panel, select "Review Tool Report". You may sort the reviews of all Review Team members by Package Reviewable Unit, Reviewer, Reviewable Unit Assessment Value, or Note/Assessments by utilizing the drop-down boxes. You also have the ability to export this report to Excel by selecting "Export to Excel."
FAQ ID:92876
SHARE URL